To make the dreams come true with lean production and management
SZCF 
June 13,2023
Sliding doors are very common in indoor home improvement. Sliding doors can save space, and are beautiful and convenient. In the past few years, sliding doors have developed a lot, and "hanging fitting sliding doors to existing wardrobe" have appeared. Do you know them?
Hanging hanging fitting sliding doors to existing wardrobe is a sliding door supported by an upper hanging wheel. This kind of door has no noise, no doorsill, beautiful and generous when it is moving.
There are two materials of profiles of hanging fitting sliding doors to existing wardrobe on the market ,titanium magnesium aluminum alloy and recycled aluminum. The high-quality hanging fitting sliding doors to existing wardrobe profiles are made of aluminum, strontium, copper, magnesium, manganese and other alloys, which has a great advantage in toughness, and the thickness can reach more than 1mm. The lower quality profiles are recycled aluminum, which causes a short service life.
Advantages of hanging fitting sliding doors to existing wardrobe
1. Concise and generous, can make your home with more modern elements.
2. By using high quality bearings, it moves quiet and smooth, only a gentle touch can you slide it smoothly.
3. It is convenient for cleaning and installation, and can be directly washed with water.
4, It is also heat insulation, blocking noise, waterproof, anti-corrosion, anti-deformation.
Installation principle
The main force of the frame structure of the hanging door is on the upper rail of the hanging door, and the performance of the hanging wheel determines the overall performance of the hanging fitting sliding doors to existing wardrobe. The upper rail of the hanging door is supported by the frame on both sides of the door, and the door is suspended by the hanging wheel under the upper rail, once you push the door, and the upper wheel slides as the door moves.
Installation method of hanging fitting sliding doors to existing wardrobe
1. open package and carefully check whether all the components are ready.
2. Take out the door frame, and place the material with the front side facing up as much as possible to avoid scratching. The floor should be covered with cardboard or carpet.
3. Put the upper hanging pulley into the upper chute in the correct order, and assemble the frame and horizontal frame correctly and tighten with half self-tapping screws (the seam must be flat). Special note: Pay attention to the arrangement position of the upper pulley to avoid rework.
4. Put the assembled door frame into the door hole. Firstly, hang the left and right door frames horizontally and vertically, punch the holes, and fix them with expansion screws (do not fix the screws too tightly for fine adjustment when installing the door leaf).
The gap is too large. Use a thin plate or other object inside.
5. Hang the door and check whether the gap between the two doors is uniform from top to bottom. If it is not uniform, fine-tune it to the proper position and test the level of the door. After everything reaches the best effect, remove the door and tighten the positioning wheel screws , Hang the door leaf again, and tighten the upper slide wheel positioning adjustment screw.
Shenzhen Chengfei reminds you to use with caution in hanging fitting sliding doors to existing wardrobe from floor to top . Because the swing amplitude is too large during sliding, the sliding door is easy to deform as time passes, and the door cannot be opened after deformation, which means that it cannot be repaired and cannot be used.
